Vivotek MD8562D Manuale Utente Scaricare il pdf (Pagina 5)

EN - 4

First, use the supplied screwdriver to detach the dome cover from the camera base. Insert your

MicroSD/SDHC Card if necessary.

Then, follow the steps below to install the camera to either a ceiling or wall:

1. Attach the supplied alignment sticker to the ceiling/wall.

2. Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall. Then hammer the

plastic anchors into the holes if necessary.

3. This Network Camera can be mounted with the cable routed through the ceiling/wall or from the

side. If you want to feed the cable through the ceiling/wall, drill a cable hole A as shown in the

picture. If the cable goes through the rear opening of the dome cover, please remove the plastic

cover (B).

4. Through the 3 holes on the camera base, insert the screws to corresponding holes and secure

the camera base with a screwdriver.

Dome Cover

Hardware Installation

Tamper-proof Screw

Camera Base

Plastic Cover

Ceiling Mount

1 2 3 4 5 6 7 8 9 10 11 12

Nessun commento

Vivotek MD8562D Manuale Utente Pagina 5